HomeDiagramsDatabaseMapsForumSkyscraper Posters
     

Go Back   SkyscraperPage Forum > Discussion Forums > Engineering

Reply

 
Thread Tools Display Modes
     
     
  #21  
Old Posted Aug 13, 2009, 4:39 AM
mthd mthd is offline
Registered User
 
Join Date: Jan 2007
Posts: 791
Quote:
Originally Posted by Coldrsx View Post
TFF to underside of slab would likely need to be 11-12' for a 9' open space.

but again, depends on what mech you spec, plumbing/risers, lighting, etc. etc.
generally not in a hotel - almost nobody tries to build hotels with a ceiling cavity of any significance. they are generally soffited over the bathrooms and corridors for venilation, sprinklers, etc, and the room itself is essentially the space between the slabs minus a couple inches at most for the floor (carpet, pad) and the ceiling (skim coat, paint, maybe just paint, maybe an acoustical treatment, etc.)

mechanical is handled with fan coil units either vertically in a wall cavity, or horizontally over the entry to the room. it would not be uncommon for a hotel to have a 9'-0" floor to floor height, an 8" thick slab, and not much over 8' clear in the room. recently constructed five stars might be a ten foot floor to floor, that same 8" slab, and 9'2" or so clear in the room.

in steel frame mixed use buildings, this can all change because of the beams, but due to the lower floor to floor height hotels are concrete more often than not....
Reply With Quote
     
     
  #22  
Old Posted Jun 4, 2017, 4:07 AM
dungks dungks is offline
BANNED
 
Join Date: May 2017
Location: Ha Noi
Posts: 1
You can use non-girder concrete floors to save on the cost of construction and architectural space for your office
Reply With Quote
     
     
End
 
 
Reply

Go Back   SkyscraperPage Forum > Discussion Forums > Engineering
Forum Jump


Thread Tools
Display Modes

Forum Jump


All times are GMT. The time now is 2:54 AM.

     

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.